Requirements
1. You MUST have 90cm or 1M dish and one other dish at any size
2. Strong Decoder(Original 4663 or 4669
3. Avatar
Installation
step one
use 90cm to track eutelsat w3 not below 64% signal quality.
Step two
track eutelsat w4, mytv or Nss7 with another dish.
Step three
connect a cable directly from the w3 lnb to the Avatar(you'll see where to
connect to it via F-connector).
Step four
remove the cable(2rsr) provided and connect it to Avatar and also connect
the other end to the back of the decoder. Make sure you tight it after fixing
the cable.
Step five
now connect your w4 cable directly from the lnb to the strong decoder
(normal connection).
Now plug the adaptor to your socket and connect to Avatar.
NOTE: MAKE SURE YOU DON'T PRESS THE REMOTE CONTROL SO THAT YOU
WILL NOT TEMPER WITH THE SETTINGS.
Next step is setting the decoder for Avatar.
1. You MUST have 90cm or 1M dish and one other dish at any size
2. Strong Decoder(Original 4663 or 4669
3. Avatar
Installation
step one
use 90cm to track eutelsat w3 not below 64% signal quality.
Step two
track eutelsat w4, mytv or Nss7 with another dish.
Step three
connect a cable directly from the w3 lnb to the Avatar(you'll see where to
connect to it via F-connector).
Step four
remove the cable(2rsr) provided and connect it to Avatar and also connect
the other end to the back of the decoder. Make sure you tight it after fixing
the cable.
Step five
now connect your w4 cable directly from the lnb to the strong decoder
(normal connection).
Now plug the adaptor to your socket and connect to Avatar.
NOTE: MAKE SURE YOU DON'T PRESS THE REMOTE CONTROL SO THAT YOU
WILL NOT TEMPER WITH THE SETTINGS.
Next step is setting the decoder for Avatar.